LOCOSTO W180 MOBILE DRIVER FOR WINDOWS

Phone goes into boot mode. If the phone powers on before Repair procedure completes, repeat whole operation from the beginning. Sigma Pack 2 Activation. Log to bookmark “Unlock”. However, in case of any hardware damage or phone warranty termination caused by TestPoint procedure Smart-Clip developer does not bear any responsibility. Do not use hot air fan to remove a metal shield on PCB.

Uploader: Kagasida
Date Added: 9 October 2012
File Size: 35.67 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 18109
Price: Free* [*Free Regsitration Required]

Models with boot versions up to 0. After that log to bookmark “Flash”, press “Enter flash mode” and continue with the step TestPoint schematics are located at Public Downloads section of www. Please note that with some models there is a single contact that should be grounded connected to the metal coverothers locosto w180 mobile two contacts that should be connected to each other.

In this case try performing “Master reset” operation and then locosto w180 mobile the code again. The Smart TestPoint v2.

SmartMoto Unlocking Manual. Smart-Clip is a professional device for unlocking cell phones.

Wait till the process finishes. This will enable you to restore the handset to its original state in case locosto w180 mobile unlock process failure. Do not use power from the battery.

Unmark option “Unlock automatically after prepare” and select the appropriate model from SmartMoto list.

Make sure that phone locodto exactly matches the model stated in the list. At this time popup window appears at SmartMoto interface. Use any other alternative tool to cut or drill locosto w180 mobile. Phone goes into boot mode.

In case if Smart-Clip has not been updated before logging in at www. Please follow this order strictly. The handset restarts and can be disconnected. Alternatively, locosto w180 mobile handset can be connected locosto w180 mobile a TestPoint method. Use the TestPoint for each specific phone model and follow the step-by-step instruction strictly. Pickup correct model from the scrolling list. Alternatively use “Automatic Model Detection” option it will recognize locosfo automatically. In most cases TP contacts are protected by a metal cover, which has to be cut or drilled for TestPoint procedure.

Some phone models require a particular procedure to be performed while using “Unlock via TestPoint” method. w1800

The prepare cycle starts. Specific procedures for each model are provided blow. The phone enters a locosto w180 mobile mode continue with the step 14, please.

Please note that the phone shouldn’t power on until the last stage completed. SmartMoto is a flashing, repairing and unlocking software meant to be used with Smart-Clip and S-Card dongle. Locoxto “Enter flash mode”. Phone doesn’t power on after that.

MPx models locosto w180 mobile a driver to be installed. SmartMoto will give the message requiring to take phone into boot mode by pressing keys combination: V3i – boot versions starting from A.

Reserve copy of security area is created. Enter “zero” 8 times.